HVAC Installation & Replacement in Milan, Michigan
Milan is about 23 minutes from our shop in Ypsilanti. A properly sized furnace and air conditioner, installed by the owner, permitted and inspected, with a free estimate and no pressure to replace what can still be repaired.
Temprasure installs furnaces, air conditioners and heat pumps across Washtenaw County, and Milan is roughly 23 minutes from our shop on Lakeridge Drive in Ypsilanti. We know the housing here. The 1890s–1930s railroad-town homes and 1960s–2000s ranches and colonials around Platt Road area usually need the venting and return air looked at before a new high-efficiency furnace goes in, and the newer builds in 48160 usually have ductwork that was never sealed and a condenser pad that has settled. A new system from us accounts for those things in the estimate instead of discovering them on install day, and the estimate is free, written, and good for a long time.
Milan houses and what that means for hvac installation
Downtown Milan and the streets around Wilson Park and Hurd Street are 1880s–1930s frame houses on stone or block basements with the original furnace location in a tight corner and a gas line that has been extended a few times. Several still have gravity-furnace duct trunks that were reused when forced air went in. The 1950s–70s ranches along Dexter Street, County Street and the Carpenter Road side of town often sit on crawlspaces or slabs, and electric baseboard or wall furnaces show up in a few that never got ductwork. Newer subdivisions off Platt Road and Arkona Road are 1990s–2000s colonials and ranches on full basements with 80 percent furnaces and R-22 condensers that are now getting replaced in bulk. On the Monroe County side and out Redman Road, we see older farmhouses with additions, mobile homes with package units, and acreage homes on well and septic.
Venting is the second thing we look at hard in Milan. A high-efficiency condensing furnace vents through the side wall in PVC, which frees up the masonry chimney that an older 80% furnace shared with the water heater. In the 1890s–1930s railroad-town homes and 1960s–2000s ranches and colonials common near the Saline River walking trail, that leaves a 40-gallon atmospheric water heater alone on a chimney that is now too large for it, and the flue gases can condense and eat the liner. We address that on the estimate, either with a chimney liner sized for the water heater or by talking through a power-vent water heater at the same time. Milan homes on DTE Energy gas also get the gas line pressure-tested and the drip leg and shutoff brought up to current code as part of the install.
With about 6,000, split between Washtenaw and Monroe Counties residents and housing that runs from the 1890s–1930s railroad-town homes and 1960s–2000s ranches and colonials around Carpenter Road corridor to the newer streets near Downtown Milan, Milan keeps us busy year-round. The equipment is on DTE Energy for heat and DTE Energy for cooling, the basements near the Milan Senior and Community Activity Center are prone to the same moisture issues as the rest of Washtenaw County, and the ductwork in a lot of these houses was never sized for the air conditioner that was bolted on later. We are 14 miles away, we service every brand, and we quote a flat rate before we start.
Local details we plan around in Milan
- The county line runs through town, so permits for a Milan address may go through the City of Milan, Washtenaw County or Monroe County depending on which side of the line the house sits.
- The Saline River floodplain around Wilson Park has put basements under water in wet springs, and we check for high-water marks on furnace cabinets in that area.
- A good share of the 1950s–60s ranches here have original 60-amp services, so adding air conditioning starts with a panel conversation.
- Milan is low, flat and open, in the Saline River bottomland, and summer humidity lingers in the older neighborhoods close to the river. The town is far enough south that it occasionally picks up weather coming off Lake Erie that misses Ypsilanti, including heavier late-winter snow and ice. With little high ground and few windbreaks between the subdivisions and the fields to the south, winter wind drives infiltration on the exposed sides of newer homes.
What Milan homeowners call about
R-22 system with a refrigerant leak
Reclaimed R-22 is scarce and expensive, and any system still using it predates 2010. Chasing a leak on one is money spent on a system near the end of its life.
Large repair on old equipment
A compressor or coil on a 15-year-old air conditioner, or a control board and blower on a 20-year-old furnace, often costs half of what a new unit does. We show you both numbers and the likely life left in the old one.
Bills climbing while comfort drops
A 60% AFUE furnace from the 1990s or an 8 SEER condenser spends a lot of your DTE bill doing nothing. Replacement pays back on fuel alone over its life, before comfort is counted.

Covered on a Milan visit
- Removal and legal disposal of old furnace, coil and condenser with refrigerant recovery
- Nitrogen-purged brazing, deep vacuum and refrigerant charge by weight verified with subcooling
- Manufacturer warranty registration in your name
- New thermostat installation and setup, including staging configuration
- Manual J heating and cooling load calculation for the house
- PVC venting for condensing furnaces or chimney liner evaluation for 80% units
How a hvac installation call works
Manual J and D sizing
A real load calculation on your house, not a rule of thumb from the old nameplate. We check that the existing ducts can carry the airflow the new system needs and tell you if they cannot.
Written options, explained
Two or three equipment configurations in writing, with the efficiency, staging and rebate picture for each, and our honest recommendation of which one fits your house and budget.
Permit and scheduling
We pull the mechanical permit with the county or city, order the equipment, and set an install date. Most furnace and AC replacements are done in one day.
Reviews from nearby homeowners
★★★★★On June 24 around 3:00 p.m., our A/C stopped working. I called several A/C repair companies and they all told me that it would take from several days to a few weeks to come out. Then I ran across Temprasure. I spoke to Al, and he came out the same day and diagnosed my 26-year-old A/C unit. The bad news is that it could not be repaired. The good news is that I purchased a new A/C unit and his team installed the new unit with no issues. Everything Al said about the installation experience actually occurred as he stated, from the delivery date of the unit to the time it took to install it. Not to mention the prices were more than reasonable.
HVAC Installation questions from Milan
Will you tell me if my Milan system does not need replacing?
Yes. That is the first question we answer on the visit. If a repair buys several more years, we quote the repair instead and encourage you to get a second opinion on anything that sounds like a replacement.
How long does a replacement take?
Most furnace and AC replacements in Milan are a single day. Adding air conditioning to a furnace-only house, new venting or duct corrections can add a day, and we tell you that in the estimate.
Which rebates apply in Milan?
Homes on DTE Energy are typically eligible for utility rebates on qualifying high-efficiency furnaces, air conditioners and heat pumps, plus the federal energy credit on certain tiers. We supply the paperwork and tell you which equipment actually qualifies.
Will the new system fix the hot upstairs in my Milan colonial?
Only if the ductwork is addressed. The Manual D check on the estimate tells us whether the returns and attic runs can deliver the airflow, and we quote any duct correction separately so you can see it.
Do you pull the permit in Milan?
Yes. Replacement furnaces, condensers and coils require a mechanical permit from Washtenaw County or the local building department, and we handle the permit and the inspection as part of the install.
Serving every part of Milan
A new furnace and air conditioner should be a once-in-twenty-years decision in Milan, made with good information rather than under pressure on a cold night. Text or call us, send a photo of the equipment label and a description of what the system is doing, and we will tell you what we think before anyone drives out to 48160. Estimates are free, DTE Energy rebate paperwork is handled, and there is no pressure to decide on the spot. Reach out when you are ready.
Neighborhoods and areas we run to regularly: Downtown Milan, Platt Road area, Carpenter Road corridor, Hurd Street neighborhood, Dexter Street corridor, Arkona Road south side, and the rest of Milan.
More in Milan
HVAC Installation nearby
HVAC Installation & Replacement in Milan, quoted before we start
Call or text (313) 701-9471. Milan is a 23-minute run for us and we are open around the clock.